Īlso the quality of the Encoders and upscale algorithms improved at even greater scale then the pure processing power of Audio processors so when ever you can you should use your hardware solution way before jumping to software solution. The same goes for DDL however here you will always have 16bit/48Khz stream. Īlso the sound quality is higher as it is real-time encoding and for DTS-I Neo6 combination you will have 24bit/96Khz stream all the time everything will be hardware upscale to this stream no matter the original source and channels.īefore there was a downside as it infused some lag as it needs time to process however this was 10-12 years ago today the processing power is 50x greater and the lag issue is actually gone. There is a good reason for this ,SRS is pure software solution and depends on main CPU & CPU accelerated technology while in other hand DDL and DTS-I are hardware solutions and use the Encoding capabilities directly from on-board Audio Chip thus reduce lag and increase overall performance. break the loop by stopping the installation then you have to do a complete manual uninstall and installation procedure which is just a bit more annoying but not a big deal. It may happen that you start circle in a loop with uninstall-install-reboot if that happens 3 times in a row. yes It works basically only with OPTICAL OUT or DIGITAL OUT Add "DisableProtectedAudioDG" of DWORD (32bit value) type and set it to 1.Īfter this reboot you should be set with DTS-I and DDL and all that beautiful shit IF BY ANY CHANCE is not check REGEDIT and if the DWORD is there and set to 1, if you followed everything and still dont have it then you are one unfortunate guy.
Go to "HKEY_LOCAL_MACHINE\SOFTWARE\Microsoft\Windows\CurrentVersion\Audio". After installation, open Run, type in "regedit" without quotes. while still in WINDOSWS open regedit and execute :ġ. STAGE2 back in windows INSTALLATION will start at some point a RED WINDOW WILL POP UP about UNCERTIFIED driver and SHIT say >YES >NO <<<Ģ. STAGE1 the driver will automatically uninstall existing driver and ask for reboot > do so
without messing with shit and that or similar run the INSTALLATION it will be in 2 stages: ĪLL you have to do is to install them normally as any other normal driver you would, ALLOW UNCERTIFIED DRIVER when asked and then after all is done apply te DWORD32 in regedir :ġ. Try the drivers I modified using the patcher created by PHYTO. It should work I have confirmation it does work with this chip, you obvious don't read because you would see the post where it is confirmed and you wouldn't have to fuck around with patching, test modes and other BS.
0 kommentar(er)
